Introduction
If the autobrake on your iniBuilds A350 turns off immediately after landing, this guide will help you check the most common causes and confirm whether the issue is related to your control bindings or manual axis input.
Issue description
Some users may find that the autobrake disengages straight after touchdown on the iniBuilds A350, even when it appears to be set correctly. In many cases, this is caused by an incorrect binding or an active manual axis input overriding the aircraft logic.
Signs
- The autobrake switches off immediately after landing
- The autobrake setting does not stay engaged as expected
- Brake behaviour changes when a controller, axis, or hardware input is moved
- The issue only occurs on the A350 and not other aircraft
Basic troubleshooting steps
Check the following before sending a support request:
- Confirm that your autobrake bindings are assigned correctly in Microsoft Flight Simulator and in any connected hardware software.
- Make sure there is no manual axis input assigned that could override autobrake behaviour.
- Remove or temporarily disable any conflicting brake, spoiler, or axis bindings.
- Test with default controller profiles where possible to rule out third-party input conflicts.
- Restart Microsoft Flight Simulator after making binding changes and test again.
Advanced troubleshooting steps
Step 1: Review your bindings
Open your control settings and check all brake-related assignments. Look for any axis or button that may be sending an input when you land, including hardware pedals, throttles, yokes, or software profiles.
Step 2: Remove manual axis input
If you have any manual brake axis mapped, temporarily clear it and retest the aircraft. Manual axis input can conflict with autobrake logic and cause the system to disengage immediately after touchdown.
Step 3: Test with a clean profile
Create or switch to a clean control profile with only the essential bindings assigned. This helps identify whether the issue is caused by a conflicting input device or profile setting.
Step 4: Record the issue
If the problem continues after checking your bindings, record a short video showing the autobrake being set, the landing, and the moment it turns off. Include any on-screen control inputs if possible.
Contact support
If the issue persists, please contact the iniBuilds support team and include the following information:
- A description of the issue
- A video of the issue in action
- Your control bindings setup
- Any relevant hardware or software being used
This will help the team investigate the behaviour more accurately and determine whether further action is needed.
Additional information
For the fastest resolution, always provide clear details about your setup and any steps you have already tried. If a binding conflict is confirmed, adjusting your control profile usually resolves the issue.